Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

KMD_PM_NO_SPD_PHASE1_FUNC_PTR
System Log Message Phase-1 SPD handler is not registered in instance:service-set
Description Phase-1 negotiation can not be initiated as initialization function failed.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
KMD_PM_P1_POLICY_LOOKUP_FAILURE
System Log Message Policy lookup for Phase-1 [negotiation-role] failed for p1_local=local-peer
p1_remote=remote-peer
Description The IKE Phase-1 negotiation with the indicated remote gateway address failed because
there is no IKE policy configured for use against the indicated remote gateway.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
KMD_PM_P2_POLICY_LOOKUP_FAILURE
System Log Message Policy lookup for Phase-2 [negotiation-role] failed for p1_local=local-peer
p1_remote=remote-peer p2_local=local-prefix p2_remote=remote-prefix
Description The IKE Phase-2 negotiation with the indicated remote gateway address failed because
the traffic selectors proposed by the remote gateway address do not match any of the
policies configured for the indicated local gateway address. The proposed traffic selectors
are indicated by the Phase-2 local and remote IP prefixes.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
KMD_PM_PHASE1_GROUP_UNREADABLE
System Log Message Unable to read group attributes from IKE Phase 1 proposal
Description The key management process (kmd) could not read the information in an Internet Key
Exchange (IKE) Phase 1 proposal about the Diffie-Hellman (DH) group to use.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
335Copyright © 2010, Juniper Networks, Inc.
Chapter 43: KMD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English