Severity error
Facility LOG_DAEMON
Action Remove the unsupported configuration statement.
RPD_IGMP_DYN_CFG_SES_ID_ADD_FAIL
System Log Message Failed to add dynamic configuration session id client-session-id to interface
interface-name.
Description Failed to associate the indicated dynamic configuration session id to specified interface.
The dynamic configuration instantiation request was rejected.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_IGMP_DYN_CFG_SES_ID_MISMATCH
System Log Message Dynamic configuration entry for interface interface-name with session id client-session-id
found an existing entry with a different session id of client-session-id-1.
Description The dynamic configuration instantiation request matched an existing dynamic
configuration block that had a different session id. The dynamic configuration instantiation
request was rejected.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_IGMP_JOIN
System Log Message Listener source-address sent a join to destination-address for group group-address source
sender-address on interface interface-name at time
Description IGMP join event.
Type Event: This message reports an event, not an error
Severity info
Facility LOG_DAEMON
RPD_IGMP_LEAVE
System Log Message Listener source-address sent a leave to destination-address for group group-address
source sender-address on interface interface-name at time
511Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...