Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Objectives
This reference describes system log messages generated by the Junos OS. Use the
information to interpret system log messages and determine the appropriate corrective
action for error conditions
NOTE: For additional information about Junos OS—either corrections to or information
that might have been omitted from this guide—see the software release notes at
http://www.juniper.net/.
Audience
This guide is designed for network administrators who are configuring and monitoring a
Juniper Networks M Series, MX Series, T Series, EX Series, or J Series router or switch.
To use this reference, you need a broad understanding of networks in general, the Internet
in particular, networking principles, and network configuration. You must also be familiar
with one or more of the following Internet routing protocols:
•
Border Gateway Protocol (BGP)
•
Distance Vector Multicast Routing Protocol (DVMRP)
•
Intermediate System-to-Intermediate System (IS-IS)
•
Internet Control Message Protocol (ICMP) router discovery
•
Internet Group Management Protocol (IGMP)
•
Multiprotocol Label Switching (MPLS)
•
Open Shortest Path First (OSPF)
•
Protocol-Independent Multicast (PIM)
•
Resource Reservation Protocol (RSVP)
•
Routing Information Protocol (RIP)
•
Simple Network Management Protocol (SNMP)
Personnel operating the equipment must be trained and competent; must not conduct
themselves in a careless, willfully negligent, or hostile manner; and must abide by the
instructions provided by the documentation.
Supported Platforms
For the features described in this manual, Junos OS currently supports the following
platforms:
•
J Series
•
M Series
Copyright © 2010, Juniper Networks, Inc.lviii
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English