Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 - Page 661

Facility LOG_DAEMON
Cause An internal software failure occurred.
Action Contact your technical support representative.
SNMP_TRAP_LINK_DOWN
System Log Message ifIndex snmp-interface-index, ifAdminStatus admin-status, ifOperStatus operational-status,
ifName interface-name
Description The SNMP agent process (snmpd) generated a linkDown trap because the indicated
interface changed state to 'down'.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
SNMP_TRAP_LINK_UP
System Log Message ifIndex snmp-interface-index, ifAdminStatus admin-status, ifOperStatus operational-status,
ifName interface-name
Description The SNMP agent process (snmpd) generated a linkUp trap because the indicated interface
changed state to 'up'.
Type Event: This message reports an event, not an error
Severity info
Facility LOG_DAEMON
SNMP_TRAP_TRACERT_PATH_CHANGE
System Log Message traceRouteCtlOwnerIndex = test-owner, traceRouteCtlTestName = test-name
Description The Simple Network Management Protocol (SNMP) remote operations process (rmopd)
generated a traceRoutePathChange trap because two probes with the same time-to-live
(TTL) value returned with different IP addresses.
Type Event: This message reports an event, not an error
Severity info
Facility LOG_DAEMON
SNMP_TRAP_TRACERT_TEST_COMPLETED
System Log Message traceRouteCtlOwnerIndex = test-owner, traceRouteCtlTestName = test-name
Description The Simple Network Management Protocol (SNMP) remote operations process (rmopd)
generated a tracerouteTestCompleted trap because the test completed and the full
path to the target was determined.
597Copyright © 2010, Juniper Networks, Inc.
Chapter 81: SNMP System Log Messages