A belt that has been replaced may not be used again.
Check the belt tension after running for approximately 15 minutes.
Old belts should be disposed of in accordance with the latest environmental regulations.
Putting in operation:
1.
Replace the belt guard.
2. Reconnect the negative battery terminal.
3. Close the cover.
Further information For replacement and tensioning of the drive belts, see also the engine manufacturer's service man‐
ual.
10.3.7 Battery maintenance
➤ Check the charging system if the battery discharges without a reason.
10.3.7.1 Safety
Danger of acid burns from escaping electrolyte!
➤ Wear appropriate protective clothing including acid-proof rubber gloves.
➤ Always wear eye and face protection.
➤ Do not tip the battery. Electrolyte may run out of the vent holes.
➤ Work with caution.
When working on the battery comply with the following safety signs:
A warning label with safety signs is attached to the battery.
Fig. 49 Safety signs - warning stickers on the battery.
10 Maintenance
10.3 Engine maintenance
126
Operator Manual Screw Compressor
M27
No.: 9_9548 05 USE
To Next Page
Loading...
