Feature Specification
Type of fuel Diesel *
Fuel consumption under LOAD mode [gal/h] 1.4
Oil consumption related to fuel consumption [%] approx. 0.2
* Use only diesel fuel to EN 590 or ASTM D975. Consult the engine manufacturer on the use of
other fuels if necessary.
Tab. 35 Engine data
2.6.2 Oil recommendation
The engine oil must meet the following classification:
■
ACEA, class E4, E7
■ API, class CF, CI-4
The engine is filled initially with engine oil of viscosity class SAE 10W–40 .
Ambient temperature [°F] Viscosity class
−22 – 86 SAE 0W–30
SAE 5W–30
−22 – 104 SAE 0W–40
SAE 5W–40
−4 – 86 SAE 1 W–30
−4 – 104 SAE 10W–40
−5 – 104 SAE 15W–40
23 – 104 SAE 20W–50
Tab. 36 Engine oil recommendation
2.6.3 Fuel recommendation
The diesel fuel must meet the requirements of EN 590 and ASTM D975 respectively.
According to these standards a specific portion of bio-diesel is permitted in the fuel.
Depending on the country of origin, bio-diesel can be produced from different plant materials and
thus have different properties.
Affected by temperature, atmospheric oxygen, and time, these bio-diesel components in the fuel
may decompose in the fuel and thus cause damages within the fuel system.
The use of other fuels as well as the mixing with additives is only permitted after consultation
with the engine manufacturer.
The engine service manual gives further information on fuel use.
2.6.4 Engine coolant recommendation
The engine coolant must meet the requirements of specification ASTM D4985.
2 Technical Data
2.6 Engine
14
Operator Manual Screw Compressor
M27 No.: 9_9548 05 USE
To Next Page
Loading...
Need help?
General
