5. Insert a new filter element in the housing. Make sure it is properly in place and sealed by its
gaskets.
6.
Replace the cap with the two retaining clips.
7. Check the correct attachment of the filter cover.
Resetting the maintenance indicator:
➤ Press the reset knob on the maintenance indicator a number of times.
The yellow piston within the indicator is reset and the maintenance indicator is ready for use
again.
➤ Close the cover.
Dispose of old parts and contaminated materials according to environmental regulations.
10.4.8 Checking safety relief valves
➤ Have safety relief valves checked by KAESER Service in accordance with the maintenance
schedule.
10.5 Cleaning the cooler
The frequency of cleaning is mainly dependent on local operating conditions.
Severe clogging of the coolers causes overheating and machine damage.
Check coolers regularly for clogging.
Avoid creating dust eddies. Wear breathing protection if necessary.
Do not clean the cooler/radiator with a sharp instrument, otherwise it could be damaged.
A severely contaminated cooler should be cleaned by
KAESER Service.
Material Compressed air
Breathing mask (if necessary)
Water or steam jet blaster
Object as support
Screwdriver
Precondition The machine is placed over a washing station equipped with an oil separator.
The machine is shut down.
The machine is cooled down.
The machine is fully vented, the pressure gauge reads 0 psig.
All compressed air consumers are disconnected and the air outlet valves are open.
The negative cable to the battery is disconnected.
10 Maintenance
10.5 Cleaning the cooler
No.: 9_9548 05 USE
Operator Manual Screw Compressor
M27
141
To Next Page
Loading...
Need help?
General
