➤ Hang the following notice on the instrument panel informing of the decommissioning measures
taken.
Attention!
1. The machine is decommissioned.
2. It is filled with preserving oil.
3. For recommissioning:
■
Take measures for recommissioning the compressor after a long period of storage.
■ Recommission according to the service manual.
Date / signature
Tab. 97 “Long-term decommissioning and storage” information notice
➤ Store in a dry place with consistent temperature.
12.2 Transport
Precondition Machine switched off and locked off.
The machine is fully vented, the pressure gauge reads 0 psig.
Machine is cooled down.
All compressed air consumers are disconnected.
All connecting lines and hoses disconnected and removed.
Any loose or movable parts that may fall when transporting are removed or secured.
12.2.1 Safety
Allow transportation only by personnel trained in safely dealing with motor vehicles and the
transporting of goods.
1.
There is danger of being run over or crushed by an overturning vehicle.
Death or serious injury can result from being crushed or run-over by a machine under tow.
➤ Riding on the machine while it is under tow is strictly forbidden.
2. Make sure the danger area is clear of personnel.
12.2.2 Towing the compressor on the road
Machines with appropriate chassis versions and running gear are approved for towing on public
roads. The machine is designed for a maximum towing speed of 60 mph. National and local regula‐
tions must be observed when towing the machine on public highways.
1.
Risk of accident when towing the unilluminated machine on public roads.
Death or severe injury possible due to accidents with unilluminated trailer.
➤ Do not tow machines without illumination on public roads.
2. Observe the safety instructions in chapter 3.5.2 "Safe machine operation".
12 Decommissioning, Storage and Transport
12.2 Transport
218
Operator Manual Screw Compressor
M27
No.: 9_9548 05 USE
To Next Page
Loading...
