2. Remove the battery (batteries) and store in a frost-free room.
3.
Make sure batteries are fully charged.
12.1.2 Long-term decommissioning and storage
Decommissioning the machine for 5 months or longer.
Material Receptacle
Preserving oil
Preservative
Desiccant
Plastic sheeting
Moisture-resistant adhesive tape
➤ The following measures must be taken for long-term decommissioning and storage:
Long-term decommissioning and storage tasks See
chapter
Complied?
➤ Check engine coolant. 10.3.1
➤ Drain the engine oil. 10.3.4
➤ Drain the oil from the oil separator tank and the oil cooler. 10.4.3
➤ Fill the separator tank and engine with preserving oil. 10.4.2
10.3.4
➤ Run the machine for about 10 minutes to coat all parts with a protec‐
tive oil film.
–
➤ Disconnect the battery, the negative terminal first and then the posi‐
tive terminal, and store in a frost-free room.
–
➤ Check the battery fluid level. 10.6
➤ Check the battery charge monthly and recharge if necessary to pre‐
vent the battery fluid freezing.
–
➤ Clean the battery terminals and coat with acid-resistant grease. –
➤ Close the compressed air outlet valves. –
➤ Use plastic sheeting and moisture-resistant adhesive tape to seal off
the following openings:
■
Engine air inlet
■ Compressor air inlet
■ Exhaust silencer
–
➤ Clean the bodywork and treat with preservative. –
➤ Hang a notice on the instrument panel informing of the decommis‐
sioning measurements taken.
–
Tab. 96 "Long-term decommissioning and storage" checklist
12 Decommissioning, Storage and Transport
12.1 De-commissioning
No.: 9_9548 05 USE
Operator Manual Screw Compressor
M27
217
To Next Page
