➤ Use only spare parts approved by KAESER for use in this machine.
➤
Carry out regular inspections:
■ for visible damage and leakage,
■ of safety devices,
■ of the EMERGENCY STOP push button,
■ of parts needing monitoring.
➤ Pay particular attention to cleanliness during all maintenance and repair work. Cover compo‐
nents and openings with clean cloths, paper or tape to keep them clean.
➤ Do not leave any loose components, tools, or cleaning rags on or in the machine.
➤ Components removed from the machine can still be dangerous.
Do not attempt to open or destroy any components taken from the machine.
➤ Use only suitable compressed air hoses.
Compressed air hoses must meet the following requirements:
■ that are of the right type and size for the highest permissible machine working pressure,
■ that are not damaged, worn or of reduced quality,
■ that have hose couplings and connections of the right type and size.
➤ Make sure compressed air hoses are depressurized before disconnecting from the machine.
➤ Secure the open end of an air hose before applying air pressure. An unsecured hose may
whiplash and cause injury.
➤ At working pressures >100 psig, compressed air hoses should be secured by a cable to their
respective outlet valves.
3.5.2.4 Parking the compressor
Improper parking and use of the parked machine endangers personnel and material.
➤ Select an even surface for parking.
➤ Use a coupled towing vehicle to move the machine into position.
➤ Place chocks under the wheels.
➤ Pull on the parking brake.
➤ Loosen the lighting and signaling system.
➤ Detach the breakaway cable / safety chain.
➤ Lower the prop stand / wind down the jockey wheel.
➤ Uncouple the compressor.
➤ Ensure that the machine is properly separated from the towing vehicle.
➤ Remove the towing vehicle from the machine.
➤ Nobody must enter the parked machine or, in particular, its chassis.
➤ Nobody must sit on the parked machine or, in particular, its towing mechanism.
3.5.2.5 Decommissioning, storage, disposal
Improper handling of old operating fluids and components represent a danger for the environment.
➤ Drain out fluids and dispose of according to environmental regulations.
These include, for example, fuel, engine oil, compressor cooling oil, and engine coolant.
➤ Dispose of the machine in accordance with local environmental regulations.
3 Safety and Responsibility
3.5 Dangers
28
Operator Manual Screw Compressor
M27 No.: 9_9548 05 USE
To Next Page
Loading...
