KAESER M27 - Page 67

Option rb/rm/rr Option rb/rm/rs
1. Use a suitable base to jack up the towing
device until the machine is in horizontal po‐
sition.
2.
Throw the clamping lever to loosen the sup‐
port's clamp.
3. Push the support downward.
4. Throw the clamping lever to secure the sup‐
port's clamp.
5. Draw out both split pins.
6. Loosen the lower locking lever.
7. Adjust the adapter.
8. Tighten the lower locking lever. Make sure
the teeth in the adjustment joint mesh to‐
gether.
9. Loosen the upper locking lever.
10. Bring the towing eye into the horizontal po‐
sition.
11. Tighten the upper locking lever. Make sure
the teeth in the adjustment joint mesh to‐
gether.
12. Secure both locking levers with a tap of a
hammer.
13. Insert both split pins.
1. Crank the jockey wheel downward until the
machine is standing horizontally.
2. Draw out both split pins.
3. Loosen the lower locking lever.
4. Adjust the adapter.
5. Tighten the lower locking lever. Make sure
the teeth in the adjustment joint mesh to‐
gether.
6. Loosen the upper locking lever.
7. Bring the overrun braking mechanism into
the horizontal position.
8. Tighten the upper locking lever. Make sure
the teeth in the adjustment joint mesh to‐
gether.
9. Secure both locking levers with a tap of a
hammer.
10. Insert both split pins.
Result Towing device is pre-assembled.
Further information Adjusting the towbar to the height of the towing device of the towing vehicle, see chapter 6.4.
6 Installation
6.3 Fitting the towbar
No.: 9_9548 05 USE
Operator Manual Screw Compressor
M27
57