Character Entry
Character Entry is the function to enter alphanumeric characters and symbols by using the [0] to[9], [G], or [H] key.
Symbols and lower-case characters can be entered by using the [0] to [9], [G], or [H] key on the keypad. The number of
key operations for entering characters can be minimized by configuring only necessary characters.
A maximum of 16 alphanumeric characters and symbols, namely 8 characters of Capital Font and 8 characters of Small
Font, can be configured for each of the [0] to [9] keys on the keypad.
A maximum of 80 alphanumeric characters and symbols can be configured for the [G] or [H] key on the keypad.
Character Entry can be used to enter a message in Short Message Mode.
Operating the Transceiver (Operation Examples for Portable)
0
If “AaBbCc...Zz” is configured for the Up and Down keys
Each time the Up key is pressed, a focused letter varies
in the predetermined order.
Each time the Down key is pressed, a focused letter varies
in the opposite order to the predetermined order.
0
If “ABCabc2” is configured for the [2] key
Each time the [2] key is pressed, a focused letter varies
in the predetermined order.
Note
0
When the Function
([W]) or [*] key is pressed, the entry mode switches as follows:
Uppercase characters > lowercase characters > numbers > uppercase characters ...
0
If the behavior of the [G]/ [H] key is configured “Line Up/Down”, the [G]/ [H] key can be used to move the cursor up
and down and characters cannot be entered.
0
Refer to “Operating the Transceiver in Each Mode (Common Operation)” for operation methods.
Configuration using KPG-D1/ D1N
Configuring Character Entry (
Transceiver Settings > Key Assignment > Character Entry)
3 BASIC OPERATIONS
3.8 Operating the Transceiver in Each Mode (Common Operation)
Common FUNC (K, F)/Ver 2.20 69
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
