EasyManuals Logo

Kenwood NX-5200K3 Common Function Reference

Kenwood NX-5200K3
476 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #234 background imageLoading...
Page #234 background image
0
For Mobile, the configuration of Bluetooth Interface Selection is retained when the transceiver migrates to FPU
Programming Mode by using SPP Connection. Therefore, when the writing of configuration data fails and the
transceiver starts up in Unprogramming Mode, Bluetooth of an RF Deck (mobile transceiver), KCH-20R (Featured
Panel), or KCH-21R (Handheld Control Head) is enabled according to the stored configuration of Bluetooth Interface
Selection. When Bluetooth is enabled, COM port 2 cannot be used. The stored configuration of Bluetooth Interface
Selection is initialized when the transceiver starts in user mode.
0
For Portable, if the writing of FPU data by using SPP Connection fails, the transceiver enters Unprogramming Mode
when the transceiver is turned ON next time. At this time, Bluetooth of an RF Deck or Featured Panel is enabled.
If Bluetooth is enabled, COM port 2 cannot be used.
0
If
a connection request by Headset Profile is received, the connection is established once; however, the connection is
immediately disconnected. The transceiver also rejects a pairing request automatically even if the request is received.
0
Bluetooth Device Name becomes the combination of Model Name and Market Code of the Kenwood ESN.
Configuration using KPG-D1/ D1N
0
Configuring Bluetooth Serial Port Profile to be enabled or disabled (
Model > Product Information > Feature
Selection)
0
Configuring Bluetooth SPP (
Setup > COM port)
Resetting the Connection by Serial Port Profile
Connection by Serial Port Profile can be reset by one of the following methods:
0
Finishing
the communication with KPG-D1/ D1N (A disconnection request is sent to the connected Bluetooth-compatible
device.)
0
Disabling Bluetooth (Refer to Toggling Bluetooth On/ Off.)
0
Moving outside the Bluetooth operation range
0
Receiving a disconnection request from a connected Bluetooth-compatible device
Note
When the transceiver is turned OFF during the connection, a disconnection request is not sent from the transceiver to the
Bluetooth-compatible device. Therefore, the Bluetooth-compatible device behaves the same as when the transceiver
moves out of range of Bluetooth.
Behavior of the Transceiver When Connecting to a Bluetooth-compatible Device
Fails (Serial Port Profile)
The connection process ends in one of the following conditions.
0
The transceiver starts connection to the Bluetooth-compatible device, and the Bluetooth-compatible device does not
respond even if about 10 sec elapse.
0
The transceiver moves outside the Bluetooth operation range during the connection process.
In
this case, if “Connecting” appears on the display, a Bluetooth No Response Tone (1 beep) sounds from the transceiver,
the LED turns Off, and “No Response” appears on the display for 1 sec. If “Connecting” does not appear on the display, the
display does not change, and no tone sounds.
10 BLUETOOTH COMMUNICATION
10.6 About Serial Port Profile (SPP Connection/ SPP Disconnection)
Common FUNC (K, F)/Ver 2.20 203
CONTENTS INDEX

Table of Contents

Other manuals for Kenwood NX-5200K3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood NX-5200K3 and is the answer not in the manual?

Kenwood NX-5200K3 Specifications

General IconGeneral
BrandKenwood
ModelNX-5200K3
CategoryTransceiver
LanguageEnglish

Related product manuals