Kenwood NX-5200K3 Common Function Reference

0
Altitude
This
function can be used to configure whether the altitudinal value appears on the transceiver display. If this function
is enabled, the altitudinal value appears on the transceiver display in GPS Position Display Mode. For convenience
of the user, either meters or feet can be configured for the format to display the altitudinal value.
If this function is disabled, the altitudinal value does not appear in GPS Position Display Mode.
Configuration using KPG-D1/ D1N
0
Configuring COM
port (
Transceiver Settings > Optional Features > Optional Features 1 > Serial Interface > COM
port)
0
Configuring Built-in GPS Receiver/Bluetooth to be enabled or disabled ( Transceiver Settings > Optional
Features > Optional Features 2 > GPS/Bluetooth)
0
Assigning functions to the PF keys on the transceiver ( Transceiver Settings > Key Assignment)
0
Configuring Latitude and Longitude
(
Transceiver Settings > Optional Features > Optional Features 2 > GPS/
Bluetooth > GPS > GPS Position Display)
0
Configuring Altitude (
Transceiver Settings > Optional Features > Optional Features 2 > GPS/Bluetooth > GPS
> GPS Position Display)
8.2
Displaying the Location Information
The transceiver enters GPS Position Display Mode if the GPS Position Display key is pressed or “GPS Position Display”
is selected by pressing the Menu key while the transceiver is in standby mode.
For Mobile, the transceiver automatically toggles between displaying the location (latitude and longitude) and the altitude
approximately every 5 sec while in GPS Position Display Mode. Pressing the Menu ([Q]) or [*] key aborts GPS Position
Display Mode.
5 seconds later
5 seconds later
Latitude and longitude
Altitude
Note
0
The
transceiver cannot enter GPS Position Display Mode if the display that appears in GPS Position Display Mode is not
configured.
0
For Mobile, pressing and holding the Menu ([Q]) or [*] key pauses the toggling of the automatic display. Pressing and
holding the Menu ([Q]) or [*] key again resumes the toggling of the automatic display.
8 GPS POSITION DISPLAY
8.1 Configuring the GPS Position Display
Common FUNC (K, F)/Ver 2.20 151
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English