Displaying a Bluetooth-compatible Device (Bluetooth My Devices)
A Bluetooth-compatible device registered for each RF Deck or KCH-20R can be confirmed. The Bluetooth-compatible device
which can be confirmed varies according to the configuration in Bluetooth Interface Selection (RF Deck, Control Head).
0
RF Deck
By
pressing the Menu key to enter Menu Mode, and then executing “Bluetooth Device”, Bluetooth Device Mode is entered.
After that, by executing Bluetooth My Devices, Bluetooth My Devices Mode is entered. In Bluetooth My Devices Mode,
the Bluetooth-compatible device registered in the Selected RF Deck can be confirmed.
0
Control Head
By pressing the Menu key to enter Menu Mode, and then executing “Bluetooth Device”, Bluetooth Device Mode is entered.
After that, by executing Bluetooth My Devices, Bluetooth My Devices Mode is entered. In Bluetooth My Devices Mode,
the Bluetooth-compatible device registered in the operated KCH-20R can be confirmed.
If any of KCH-19, KCH-20R, and KCH-21R coexist, and if the operated Control Head is KCH-19, a Key-entry Error Tone
sounds from the Control Head, and the Control Head does not respond.
VOX
VOX is the function to enable the transmission without pressing the PTT switch,
just by inputting the audio to a microphone
of the headset which supports Bluetooth.
In a Multi RF Deck/ Multi Control Head structure, the available operations increase compared with Single RF Deck/ Single
Head Multi. The VOX behavior varies according to the configuration in Bluetooth Interface Selection (RF Deck, Control
Head).
0
RF Deck
By pressing the VOX key, or by pressing the Menu key to enter Menu Mode and then executing “VOX”, VOX for the
Selected RF Deck can be toggled between on and off.
If VOX is enabled, and if the audio is inputted to a microphone of the headset, the RF Deck connected to the headset
starts transmitting.
If Cancel Operation is enabled, VOX will be disabled when one of the following operations is executed by the Selected
RF Deck or the Unselected RF Deck:
For the Selected RF Deck:
0
Pressing the PTT switch of Control Head 1 or Control Head 2
0
The External PTT (Voice) port (AUX Input) of the Selected RF Deck goes low level
0
Pressing the PTT switch of the headset connected to the Selected RF Deck
For the Unselected RF Deck:
0
The External PTT (Voice) port (AUX Input) of the Unselected RF Deck goes low level
0
Pressing the PTT switch of the headset connected to the Unselected RF Deck
16 MULTI RF DECK/ MULTI CONTROL HEAD
16.16 Bluetooth Communication
Common FUNC (K, F)/Ver 2.20 309
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
