Power-on Tone
A Power-on Tone sounds from the transceiver when the transceiver is turned ON.
The volume level of Power-on Tone can be configured using KPG-D1/ D1N. (Refer to Configuring the Volume Level of
Various Tones (Tone Volume).)
Table 6-2 Power-on Tone
Function Description
Power-on Tone A This tone sounds from the transceiver when the transceiver is turned ON.
Power-on Tone B
(Mobile only)
This tone sounds when the transceiver is turned ON by pressing and holding the Power switch
while
“ Ignition & Switch” is configured in Ignition Sense Type. In this case, Timed Power-off is
not activated.
Configuring a tone which sounds when the transceiver is turned ON (Power-on Tone)
The tone pattern (frequency and length) for a Power-on Tone A which sounds from the transceiver when the transceiver is
turned ON can be configured using KPG-D1/ D1N.
The
default for a Power-on Tone A is a frequency of 1480 Hz and a tone length of 500 ms. The tone length can be extended
up to 1000 ms.
Configuration using KPG-D1/ D1N
Configuring Power-on Tone (
Transceiver Settings > Special Tone)
Control Tone
A Control Tone sounds when a function is activated by a user operating the transceiver.
The
volume level of Control Tone can be configured using KPG-D1/ D1N. (Refer to Configuring the Volume Level of Various
Tones (Tone Volume).)
Table 6-3 Control Tone
Function Description
Key Beep A This tone sounds from the transceiver when a function is enabled by pressing a key.
Key Beep B This tone sounds from the transceiver when a function is disabled by pressing a key.
Key Beep C
This tone sounds from the transceiver when Home Channel or Direct Channel is changed using
the Home Channel Select or Direct Channel Select key, or when the time in the transceiver is
changed in Clock Adjustment Mode.
Key-entry Error Tone This tone sounds from the transceiver when the operation activated by pressing a key is denied.
Rollover Tone
This tone sounds from the transceiver when the lowest zone or channel number is selected. Also,
this tone sounds if the lowest list number is selected in various list modes, or if the smallest font
or lowest value is selected while entering characters or code. (Refer to Rollover/ End Stop.)
Stop Tone
This tone sounds from the transceiver if “End Stop” is configured in Rollover/ End Stop.
This
tone sounds from the transceiver if the zone or channel number is decreased while the zone
or channel having the lowest number is selected. Or, this tone sounds from the transceiver if the
zone or channel number is increased while the zone or channel having the lowest number is
selected. (Refer to Rollover/ End Stop.)
Password
Authorization Tone
This tone sounds from the transceiver if the entered password matches the password
preconfigured for the transceiver.
6 SOUND
6.1 Tones that Sound When a User Operates the Transceiver or When the Transceiver Status Is Changed
Common FUNC (K, F)/Ver 2.20 107
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
