7.3
Warning the Battery Power of the Vehicle Battery Is Low
(Battery Warning)
Supported Models: Mobile
Battery
Warning for Mobile notifies a user by the LED or warning tone that a transmission is restricted because the battery
power of the vehicle battery is low.
If the battery power of the vehicle battery goes lower than the threshold (8.5 V), the LED flashes red and a Battery Warning
Tone sounds from the transceiver. If the battery power of the vehicle battery recovers to the threshold (8.5 V), the flashing
of the LED and the Battery Warning Tone stop.
If the power of the vehicle battery is lower than the threshold (8.5 V) when transmitting, transmission cannot occur. In this
case, while the PTT switch is being pressed. a Warning Tone A (continuous beep) sounds from the transceiver. The threshold
(8.5 V) is not determined while transmitting.
Note
For Mobile, Battery Warning cannot be configured by using KPG-D1/ D1N and always functions as above.
7.4
Displaying the Remaining Battery Power by Operating the
Transceiver (Battery Status)
Supported Models: Portable
By
flashing the LED red or emitting a Beep, Battery Status notifies a user of the remaining battery power by operating the
key of the transceiver.
Battery Status is executed by pressing the Battery Status key.
Or, Battery Status is executed by selecting “Battery Status” after placing the transceiver in Menu Mode by pressing the
Menu key.
(Refer to Using Menu Mode.)
If Battery Status is executed, the LED flashes red depending on the remaining battery power. Also, if Battery Level Tone
is enabled, a Battery Level Tone (1 beep) sounds from the transceiver depending on the remaining battery power.
Table 7-4 Battery Status
Status Number of LED Flashes Number of Battery Level Tones
Full 4 times 4 times
Sufficient 3 times 3 times
Low 2 times 2 times
Very Low 1 time 1 time
Note
If the following, Battery Status does not operate:
0
While the transceiver is in Emergency Mode
0
While the transceiver is transmitting
0
While the transceiver is executing Battery Warning
0
While the transceiver is in Transceiver Password Mode
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
0
Configuring Battery Level Tone
(
Transceiver Settings > Optional Features > Optional Features 1 > Battery)
7 BATTERY
7.3 Warning the Battery Power of the Vehicle Battery Is Low (Battery Warning)
Common FUNC (K, F)/Ver 2.20 146
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
