5
Complete pairing.
When pairing completes, the Bluetooth-compatible device is registered in the transceiver, and the connection
process starts by HSP Connection.
If a connected Bluetooth-compatible device exists, the connection process starts after the connection is reset.
A Ring Tone sounds from the Bluetooth-compatible device during the connection process. In this case, start-up
operations need to be done on the Bluetooth-compatible device. Refer to the instruction manual supplied with the
Bluetooth-compatible device for details on the start-up operations.
12 : 34
A
M
Connecting
Find Device 1
The mic and speaker of the Bluetooth-compatible device can be used when the connection process completes. In
this case, a Bluetooth Connect Tone (2 beeps) sounds from the transceiver, the “ ” icon blinks, and “Connected”
appears for 1 sec. Also, the LED turns Off.
Menu Zone
+
Zone 1
Channel 1
12 : 34
A
M
Connected
Note
0
The connection process continues even if a Voice Call or Data Call is received during the connection process.
0
Mode Reset Timer is extended during the connection process.
Registering and Connecting Using PF Keys (Define Bluetooth Device)
Pairing can be started for a Bluetooth-compatible device having an address configured in Define Bluetooth Device.
Operating the transceiver
1
Press the Bluetooth Connect / Disconnect key when a connected Bluetooth-compatible device does not
exist.
A Key Beep A (1 beep) sounds from the transceiver and pairing starts. An LED flashes blue during pairing.
Menu Zone
+
Zone 1
Channel 1
12 : 34
A
M
Connecting
10 BLUETOOTH COMMUNICATION
10.3 Registering and Connecting a Bluetooth-compatible Device to the Transceiver (Pairing/ HSP Connection)
Common FUNC (K, F)/Ver 2.20 186
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
