Configuration using KPG-D1/ D1N
0
Configuring Bluetooth
Headset Connection Type (Control Head 2) (
Transceiver
Settings > Optional Features
> Optional Features 2 > GPS/Bluetooth > Bluetooth > Control Head 2)
0
Configuring Bluetooth Headset Connection Type (Portable) (
Transceiver Settings > Optional Features >
Optional Features 2 > GPS/Bluetooth > Bluetooth > Portable)
0
Configuring Bluetooth
Headset Connection Type (RF Deck/Control Head 1) (
Transceiver
Settings > Optional
Features > Optional Features 2 > GPS/Bluetooth > Bluetooth > RF Deck/Control Head 1)
Resetting the Connection by Headset Profile
Connection by Headset Profile can be reset by one of the following methods:
0
Pressing the Bluetooth Connect / Disconnect key when a connected Bluetooth-compatible device exists
0
Placing
the transceiver in Bluetooth My Devices Mode, selecting a connected Bluetooth-compatible device, and pressing
the Menu ([Q]) or [*] key (Refer to Displaying a Bluetooth-compatible Device (Bluetooth My Devices).)
0
Disabling Bluetooth
0
Moving outside the Bluetooth operation range
0
Receiving a disconnection request from a connected Bluetooth-compatible device
If connection by Headset Profile is reset by any of these methods, a Bluetooth Disconnect Tone (2 beeps) sounds from the
transceiver, the “V” icon blinks, and “Disconnected” appears on the display for 1 sec.
Menu Zone
+
Zone 1
Channel 1
12 : 34
A
M
Disconnected
Also, connection by Headset Profile can be reset even by the following methods:
0
Turning the transceiver OFF
0
Disabling Bluetooth (Refer to Toggling Bluetooth On/ Off.)
10 BLUETOOTH COMMUNICATION
10.5 About Headset Profile (HSP Connection/ HSP Disconnection)
Common FUNC (K, F)/Ver 2.20 200
CONTENTS INDEX