10.4
Displaying a Bluetooth-compatible Device (Bluetooth My
Devices)
Bluetooth My Devices is the function to display a Bluetooth-compatible device registered in the transceiver.
If the transceiver enters Bluetooth My Devices Mode, a Bluetooth-compatible device registered in the transceiver appears
on the display.
The following operations are enabled in Bluetooth My Devices Mode:
0
The connection to the selected Bluetooth-compatible device can be made by using Headset Profile.
0
The connection to the connected Bluetooth-compatible device by Headset Profile is reset.
0
The
registration of a Bluetooth-compatible device can be reset if the connection has not been made by using Headset
Profile or Serial Port Profile.
Pressing the Menu key causes the transceiver to enter Menu Mode, and then the transceiver enters Bluetooth My Devices
Mode by executing “Bluetooth My Devices” after executing “Bluetooth Device”. (Refer to Using Menu Mode.)
Operating the transceiver
0
Placing the transceiver in Bluetooth My Devices Mode
1
Press the Menu key to enter Menu Mode and then execute “Bluetooth Device”.
Pressing the [G]
or [H] key to select “Bluetooth Device” and then pressing
the Menu ([Q]) or [*] key causes the transceiver to enter Bluetooth Device
Mode. (Refer to Using Menu Mode.)
2
Press the [ ] or [ ] key to select “My Devices”, and then press the Menu
([
]) or [ ]
key.
A Key Beep A (1 beep) sounds from the transceiver, and then the
transceiver enters Bluetooth My Devices Mode.
If a Bluetooth-compatible device registered in the transceiver does not
exist,
a Key-entry Error Tone (1 beep) sounds from the transceiver and “BT
No Device” appears on the display.
12 : 34
A
M
My
Devices
Find Device
BackNext
BT Device
1
12 : 34
A
M
LMIC
C11-100047-HP
Conn Delete
My Devices 1
12 : 34
A
M
BT No Device
My Devices
Back
10 BLUETOOTH COMMUNICATION
10.4 Displaying a Bluetooth-compatible Device (Bluetooth My Devices)
Common FUNC (K, F)/Ver 2.20 193
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
