2
Press the Home Channel key again.
A Key Beep B (2 beeps) sounds from the transceiver, and then the
transceiver returns to the previous channel.
Menu Zone
+
Zone 1
Channel 15
12 : 34
A
M
0
Changing the Home Channel
1
Select the channel to be configured as the Home Channel.
2
Press the Home Channel Select key.
A Key Beep C (3 beeps) sounds from the transceiver, and then the Home
Channel is changed. “Home” appears on the display at the same time.
Menu Zone
+
Zone 1
Channel 15
12 : 34
A
M
Menu Zone
+
Home
Zone 1
Channel 15
12 : 34
A
M
Configuration using KPG-D1/ D1N
0
Configuring Home Channel ( Transceiver Settings > Zone/Channel > Zone Edit > General)
0
Assigning functions to the PF keys on the transceiver ( Transceiver Settings > Key Assignment)
Direct Channel
Direct Channel is the function to migrate the transceiver to a preconfigured channel by pressing one of the Direct Channel
1
to Direct Channel 5 keys. The transceiver can move to and from channels in each zone.
Also, pressing one of the Direct Channel 1 Select to Direct Channel 5 Select keys can change the Direct Channel.
Or, pressing the Menu key causes the transceiver to enter Menu Mode, and then the Direct Channel can be changed by
selecting one of “Direct Channel 1 Select” to “Direct Channel 5 Select”. (Refer to Using Menu Mode.)
Note
If the Return function is enabled, pressing one of the Direct
Channel 1 to Direct Channel 5 keys during the scan pauses
scanning while the transceiver is migrating to the Direct Channel, and then a Scan Stop Tone (2 beeps) continuously
sounds from the transceiver at 30-sec intervals.
3 BASIC OPERATIONS
3.5 Changing the Zone-channel
Common FUNC (K, F)/Ver 2.20 46
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
