Kenwood NX-5200K3 Common Function Reference

Using Sound to Notify the Other Party that the Communication Ends (PTT Release
Tone)
PTT Release Tone
is the function to notify the receiving party by audible tone that a communication ended by releasing the
PTT switch when the communication ends. With this function, knowing an audible tone marks the end of a call will allow the
receiving party to easily recognize the timing to transmit next.
The transceiver transmits the PTT Release Tone (1 beep) and then ends the actual transmission when the call finishes by
releasing the PTT switch.
PTT Off
PTT Release Tone
PTT On
Transmit
Receive
Figure 6-1 PTT Release Tone
The volume level of PTT Release Tone can be configured in Transmit Tone Level.
Configuration of PTT Release Tone in an LTR Trunking system
In an LTR Trunking system, the enabling and disabling of PTT Release Tone when transmitting a Dispatch ID and the
enabling and disabling of PTT Release Tone when transmitting a Telephone ID can each be configured. This can be
configured individually in order to avoid double beeping when using a Telephone ID, since some repeaters have a function
similar to Telephone ID.
Note
If EOT for DTMF or MDC-1200 is configured, the PTT Release Tone is sent after the EOT is sent. If EOT for FleetSync
is configured, a PTT Release Tone is sent after the EOT is sent.
Configuration using KPG-D1/ D1N
0
Configuring PTT Release Tone (NXDN Trunking) to be enabled or disabled ( Transceiver
Settings > Personal >
Personal Features > NXDN Trunking > General)
0
Configuring PTT Release Tone (P25 Trunking) (Personality) to be enabled or disabled (
Transceiver Settings >
Personal > Personality > P25 Trunking)
0
Configuring PTT Release Tone (P25 Trunking) (Channel Table) to be enabled or disabled ( Transceiver Settings
> Zone/Channel > Channel Edit > P25 Trunking)
0
Configuring PTT Release Tone (Conventional) to be enabled or disabled ( Transceiver Settings > Optional
Features > Optional Features 2 > Conventional)
0
Configuring PTT Release Tone (LTR Trunking) to be enabled or disabled (
Transceiver Settings > LTR)
0
Configuring Transmit Tone Level ( Transceiver Settings > Optional Features > Optional Features 1 > Sound)
6 SOUND
6.3 Tones that Sound When the Communication Starts/ Ends
Common FUNC (K, F)/Ver 2.20 119
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English