Configuration using KPG-D1/ D1N
0
Configuring Transceiver Password ( Transceiver Settings > Optional Features > Optional Features 1 >
Password)
0
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
13.2
Password When Reading Configuration Data in a PC (Read
Authorization Password)
Read Authorization Password is the function to protect the configuration data, such as the operating frequencies, from
being read by unauthorized persons if the transceiver should ever be stolen.
To
read data using KPG-D1/ D1N from the transceiver with Read Authorization Password configured, Read Authorization
Password needs to be entered on a PC. The configuration data in the transceiver cannot be read unless the correct
Password is entered.
Read Authorization Password can be configured for the transceiver using KPG-D1/ D1N. Read Authorization
Password can be configured using any numbers between 0 and 999999 inclusive.
Note
If the password authentication fails consecutively for the number of times configured in Password Entry Limit, the
transceiver enters Transceiver Lockout Mode, and then “LOCKOUT” appears on the display. In Transceiver Lockout
Mode, the transceiver cannot be operated. Writing configuration data to the transceiver by using KPG-D1/ D1N, the
transceiver exits Transceiver Lockout Mode.
Also, a failure in Overwrite Password authentication counts as a failure in the password authentication. The number of
failures in the password authentication is cleared by one of the following conditions:
0
When the transceiver is turned OFF and then turned ON again
0
When the correct password is entered
0
When configuration data is written to the transceiver by using KPG-D1/ D1N
Configuration using KPG-D1/ D1N
0
Configuring Read
Authorization Password (
Transceiver Settings > Optional Features > Optional Features 1 >
Data Password > Read Authorization Password)
0
Configuring Password Entry Limit ( Transceiver Settings > Optional Features > Optional Features 1 > Data
Password)
13 TRANSCEIVER DATA PROTECTION WITH PASSWORD
13.1 Password for Transceiver Operation (Transceiver Password)
Common FUNC (K, F)/Ver 2.20 235
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
