2.5
Embedding a Message in the Transceiver (Embedded
Message)
The message can be written to the transceiver as part of the configuration data by using KPG-D1/ D1N.
Embedded Message
Embedded Message can be used to store a maximum of 64 characters in the transceiver. The transceiver profile
information, such as the control number and the file name of the configuration data written in the transceiver, can be
embedded.
The
message can be written to the transceiver by using KPG-D1/ D1N. The message written in the transceiver is stored as
a part of the configuration data.
The embedded messages can be read from the transceiver by using KPG-D1/ D1N.
Configuration using KPG-D1/ D1N
Configuring Embedded Message (
Transceiver Settings > Embedded Message)
Embedded Message with Password
Embedded Message with Password can be used to store with a password a maximum of 64 alphanumeric characters
and symbols in the transceiver.
The transceiver profile information, such as the control number and the file name of configuration data written in the
transceiver, can be embedded with a password.
The message and the password can be written to the transceiver by using KPG-D1/ D1N. The Embedded Message with
Password is stored in the transceiver as independent data from the configuration data.
The
password needs to be entered to write a message to the transceiver written with a password. The message cannot be
written to the transceiver unless the correct password is entered.
The embedded messages can be read from the transceiver by using KPG-D1/ D1N.
Configuration using KPG-D1/ D1N
Configuring Embedded Message with Password
(
Transceiver Settings > Embedded Message with Password)
2 GETTING STARTED
2.5 Embedding a Message in the Transceiver (Embedded Message)
Common FUNC (K, F)/Ver 2.20 24
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
