3.6
Transmitting/ Receiving
The PTT
switch can be used to transmit and receive.
Receiving
Received audio sounds from the speaker when the transceiver receives a signal and conditions to unmute the speaker are
satisfied. To respond, speak into the microphone while pressing the PTT switch.
Transmitting
Transmitting can be initiated by selecting the desired Zone-channel and then pressing the PTT switch.
Audio is transmitted
by speaking into the microphone while pressing the PTT switch. Releasing the PTT switch terminates transmitting.
Conditions to unmute the speaker while receiving, the transceiver behavior while transmitting, or communication methods,
such as an individual call or group call, vary according to the system in use. Refer to each Function Reference for
communication methods in each system.
In addition, for Mobile, various communications can be done using the external ports of the transceiver. Refer to “D-sub 25-
pin Connector” for the function of the external ports of Mobile.
Note
Audio characteristics of the microphone and speaker for transmitting and receiving can be configured in Audio Profile.
(Refer to Configuring Audio Profile (Audio Profile).)
3 BASIC OPERATIONS
3.6 Transmitting/ Receiving
Common FUNC (K, F)/Ver 2.20 48
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
