Keysight EDU33210 Series - Page 58

3. Set the "hop" frequency.
Press the Hop Freq softkey and then set the value to 500 Hz using the numeric keypad or the knob and arrows. If you
use the numeric keypad, be sure to finish the entry by pressing Hz.
4. Set the FSK "shift" rate.
Press the Fsk Rate softkey and then set the value to 100 Hz using the numeric keypad or the knob and arrows.
At this point, the instrument outputs an FSK waveform if the channel output is enabled.
58
Keysight EDU33210 Series User's Guide