If you move your cutter frequently, it is possible for the laser to shift slightly. Periodically, you may want to
do a check of the print and cut accuracy to make sure the calibration is still precise. Refer to Chapter 9, if
you plan to be using your Klic-N-Kut for print and cut applications.
If you cut vinyl or other backed materials regularly, you may need to replace the cutting strip at some point.
You will be able to tell based on seeing deep cuts in the strip and an inconsistency in the cutting. Contact
KNK USA for information on obtaining a replacement.
For any other questions or concerns about maintaining your KNK, please post at our user forum:
http://knkusa.com/forums/
To Next Page
Loading...
