KNK Zing Air - Introduction; Unpacking; Contents; Items to Note (Please Read!)

9
1. Introduction
1.01 Unpacking
 Verify that you have received all contents. There is a checklist below. Please notify your Zing Air supplier
immediately if anything is missing.
 Remove all foam pieces and other packaging before turning on the Zing Air. Currently there are two end cap
foam protectors and 3 internal smaller foam pieces, as well as two black plastic pieces supporting the pinch
wheel bar.
 Use the enclosed test pen as you experiment and become familiar with operating the Zing Air. Place scrap
paper on the mat and simply draw shapes rather than cut them. This will prevent possible damage to the
blade, mat, and cutting strip as you learn where shapes will cut and the basic operating procedures.
 Do not unplug the USB cable from your computer or from the Zing Air unless you first turn off the power.
 Always turn off the Zing Air when not in use. Leaving the cutter turned on for extended periods of time can
possibly damage the machine.
1.02 Contents
 Your KNK Zing Air package comes with the following:
KNK Zing Air digital die cutter Blade holder
USB – Blue Tooth adaptor 45˚blade (red cap)
Power cable 60˚blade (blue cap)
Cutting Mat 2 small springs for blades
Test Pen USB cable
2 test pen inserts and a spring
1.03 Items to Note (Please Read!)
 Blades: The blades used by cutters are extremely fragile. Do not drop or even bump the blade onto any
hard surface as they can chip easily. When not in use, retract the blade into the blade holder or remove and
cover the sharp end with the soft plastic cap. Be careful to keep these small blades and their springs in a
safe place.
 Warranty: The one year warranty covers Manufacturer’s Defect only and does not include normal wear and
tear. If warranty work is required, the owner is responsible for shipping costs to and from Accugraphic Sales.
If a KNK Zing Air is damaged during shipment, then your dealer should be notified as soon as possible. If
damages are reported later than three weeks after delivery, then it will be the responsibility of the owner to
ship the damaged KNK back to Accugraphic for repair.
 Zing Air owners outside the USA should contact their distributor for procedures regarding warranty work or
shipping damage.
 Transporting: When transporting the cutter, move the pinch wheel levers into the upward position. Remove
the accessories from the Zing Air and place in a separate bag. We also recommend retaining the original
boxes with the foam inserts in case you ever need to ship your KNK Zing Air.
 Additionally:
 DO NOT touch or jam the plotter’s track while it is operating. If the cutter is damaged, it is the owner’s
responsibility.