Kollmorgen - December 2011 19
MMC Smart Drive Hardware Manual - INSTALLING THE MMC SMART DRIVE
3 Installing the MMC Smart Drive
3.1 Storing the Drive Before Installation
The drive should remain in the shipping container prior to installation. If the equipment
is not to be used for a period of time, store it as follows:
• Use a clean, dry location
• Maintain the storage temperature and humidity as shown in the specifications
section of this manual.
• Store it where it cannot be exposed to a corrosive atmosphere
• Store it in a non-construction area
3.2 Unpacking the Drive
Remove all packing material, wedges, and braces from within and around the
components. After unpacking, check the name plate Material Number against the
purchase order of the item(s) against the packing list. The model number, serial
number and manufacturing date code are located on the side of the unit.
3.3 Handling an MMC Smart Drive
The case protects the MMC Smart Drive’s internal circuitry against mechanical
damage in shipping and handling.
However, like any electronic device, the circuitry can be destroyed by:
• Conditions exceeding those detailed in the specifications tables shown in the
Specifications sections in this manual.
• moisture condensing inside the module
• static discharge
• exposure to a magnetic field strong enough to induce a current in the circuitry
• vibration, and other hazards
3.4 Inspecting the Drive Before Installation
Inspect the unit for any physical damage that may have been sustained during
shipment.
If you find damage, either concealed or visible, contact your buyer to make a claim
with the shipper. If degraded performance is detected when testing the unit, contact
your distributor or Kollmorgen. Do this as soon as possible after receipt of the unit.
NOTE
The National Electrical Code and any other governing regional or local
codes overrule the information in this manual. Kollmorgen does not assume
responsibility for the user’s compliance or non-compliance with any code,
national, local or otherwise, for the proper installation of this drive and asso-
ciated systems or equipment. Failure to abide by applicable codes creates
the hazard of personal injury and/or equipment damage.
To Next Page
Loading...