Kollmorgen - December 2011 237
MMC Smart Drive Hardware Manual - MOTOR CABLES & CONNECTORS
• The cable must be able to move freely in the track
• The cable must be able to move in the radius section of the track. This must be
checked in the track’s fully extended position.
• When cables of different diameters are installed, the use of vertical separators or
horizontal shelving is recommended. Cables of similar diameters can be put in the
same compartment.
• Cables should never be put on top of one another in high velocity or high cycle
applications.
• The cable’s weight should be distributed symmetrically over the chain width.
To Next Page
Loading...