KSB PumpDrive 2 - Page 137

10 Parameter List PumpDrive 2
137 of
212
Parameter Description Help text Possible settings Unit Factory setting
1-2-4-4 M12 Module Input A
Value
Current signal value present at analog input
A of the M12 module
mA
1-2-4-5 M12 Module Input B
Value
Current signal value present at analog input
B of the M12 module
mA
1-2-4-6 Digital Inputs Display of the current statuses of the digital
inputs
1-2-4-7 Digital Outputs Display of the current statuses of the digital
outputs
1-2-4-8 Analog Output 1 Value Current signal value output at analog
output 1 of the control PCB
mA
1-2-4-9 Analog Output 2 Value Current signal value output at analog
output 2 of the I/O extension board
mA
1-3 Open-loop Control Current signal value present at analog
input 3 of the I/O extension board
mA or V
1-3-1 System Start / Stop This function is used to start the system. ▪ Stop
▪ Start
Stop
1-3-2 Setpoint (Closed-loop
Control)
Configurable setpoint. This parameter is
disabled if the setpoint is specified via
DIGIN/ANIN. Otherwise, the setpoint source
is selected via the Control Point parameter
(Local/Field Bus).
Minimum to maximum limit of value range
set
Dependent on the
controlled
variable set
0,00
1-3-3 Control Value (Open-
loop Control)
Configurable control value for speed in
open-loop control mode
3-2-2-1 … 3-2-2-2 rpm 3-2-2-1
1-3-4 Control Value (Manual) When manual mode is activated, the
current operating speed is accepted;
otherwise, minimum speed is used. The
speed can then be set in manual mode.
3-2-2-1...3-2-2-2 rpm 3-2-2-1
1-3-5 Immediate Pump
Changeover
This function is used to change pumps
directly.
Run
1-3-6 Immediate Functional
Check Run
This function is used to perform the
functional check run for this pump directly.
Run
1-3-7 Immediate Pipe Flushing This function allows the pipe flushing
function to be started manually once.
Run
1-3-8 Operating Mode Setting the operating mode ▪ OFF
▪ Manual Mode
▪ Automatic Mode
Automatic Mode
1-3-9 Alternative Values