3-S7
MX5100, WSM
TRANSMISSION
Bonnet and Battery Negative Cable
1. To open the bonnet (1), hold the bonnet (1) with a hand and pull
the release lever (2) and open the bonnet (1).
2. Disconnect the battery negative cable (3).
3. Disconnect the head light connector (6).
4. Remove the snap pins (8).
5. Disconnect the bonnet dampers (7) from the bonnet (1).
6. Remove the bonnet (1) carefully.
(When reassembling)
• To close the bonnet, push the bonnet into position using both
hands.
W1095509
(1) Bonnet
(2) Release Lever
(3) Battery Negative Cable
(4) Battery Negative Cable
(5) Battery
(6) Head Light Connector
(7) Bonnet Damper
(8) Snap Pin
To Next Page
Loading...
