Kubota MX5100 - 4 Lubricants, Fuel and Coolant

G-8
MX5100, WSM
G GENERAL
4. LUBRICANTS, FUEL AND COOLANT
* KUBOTA original transmission hydraulic fluid.
Place
Capacity
Lubricants, fuel and coolant
MX5100
1 Fuel tank
48.0 L
12.7 U.S.gals
10.6 Imp.gals
No. 2-D diesel fuel
No. 1-D diesel fuel if temperature is below
−10 °C (14 °F)
2
Cooling system with
recovery tank
7.0 L
7.4 U.S.qts
5.8 Imp.qts
Fresh clean water with anti-freeze
3
Engine crankcase
(with filter)
8.0 L
8.5 U.S.qts
7.0 Imp.qts
Engine oil : API service CF or better. Refer to
next page.
Below 0 °C (32 °F) : SAE10W, 10W-30 or
15W-40
0 to 25 °C (32 to 77 °F): SAE20, 10W-30 or
15W-40
Above 25 °C (77 °F): SAE30, 10W-30 or
15W-40
4 Transmission case
44.0 L
11.6 U.S.gals
9.7 Imp.gals
KUBOTA UDT fluid or KUBOTA SUPER UDT
fluid*
5 Front axle case (4WD)
9.0 L
9.5 U.S.qts
7.5 Imp.qts
KUBOTA UDT fluid, KUBOTA SUPER UDT
fluid*, SAE80 or SAE90 gear oil
Greasing
Place No. of greasing point Capacity Type of grease
6
Front wheel hub
(2WD)
2 Moderate amount
Multipurpose grease
NLGI-2 or NLGI-1
(GC-LB)
Knuckle shaft (2WD) 2
Until grease overflows.
Front wheel case
support (4WD)
2
Front axle support
(4WD)
2
Top link 2
Top link bracket
2 (with draft control if
equipped)
Lift rod 1
Battery terminals 2 Moderate amount