7-S11
MX5100, WSM
STEERING
(2) Steering Wheel and Steering Controller
• Use only the transmission fluid (See page G-8), in no case use mixture of oils of different brands.
• Before disassembling the power steering system hydraulic components, check the performance of
hydraulic pump and power steering using a flowmeter.
Do not disassemble the power steering needlessly.
• After removing or disassembling the power steering hydraulic components, be sure to bleed air.
• If disassembly of power steering is needed, perform disassembly carefully following the instructions given
below.
1. Since the sliding surfaces of those parts have seen precisely finished, do not brush or grind with
sandpaper. Use transmission fluid for cleaning and compressed air for blowing off.
2. When reassembling, inspect each part for wear and damage. If seriously damage, replace parts as sub-
assembly or assembly.
[Bleeding Air in the Power Steering Hydraulic System]
1. Start the engine.
2. Turn the steering wheel slowly in both directions all the way alternately several times bleed the air in the power
steering hydraulic system, and stop the engine.
[Component Parts of Steering Controller]
1. In MX5100, component parts of the steering controller are not adopted. The component parts are not provided by
Kubota.
2. If the oil leakage from the steering controller assembly is found, replace the steering controller as an assembly.
To Next Page
Loading...
