Kubota MX5100 - Check Point of Every 1 Year; Check Points of Every 2 Years

G-38
MX5100, WSM
G GENERAL
[11] CHECK POINT OF EVERY 1 YEAR
Replacing Air Cleaner Primary Element and Secondary Element
1. Remove the air cleaner cover (3).
2. Replace the air cleaner primary element and the secondary
element.
NOTE■
• Check to see if the evacuator valve is blocked with dust.
IMPORTANT■
• The air cleaner uses a dry element, never apply oil.
• Do not run the engine with filter element removed.
• Be sure to refit the cover the arrow ↑ (on the rear of cover)
upright. If the cover is improperly fitted, evacuator valve will
not function and dust will adhere to the element.
W10931910
[12] CHECK POINTS OF EVERY 2 YEARS
Flushing Cooling System and Changing Coolant
CAUTION
• Do not remove the radiator cap while coolant is hot. When
cool, slowly rotate cap to the first stop and allow sufficient
time for excess pressure to escape before removing the cap
completely.
1. Stop the engine, remove the key and let it cool down.
2. To drain the coolant, open the radiator drain cock (1) and remove
the radiator cap (2). The radiator cap (2) must be removed to
completely drain the coolant.
3. After all coolant is drained, close the drain cock (1).
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until the coolant
level is just below the radiator cap. Install the radiator cap (2)
securely.
7. Fill with coolant up to “FULL” mark on the recovery tank.
8. Start and operate the engine for few minutes.
9. Stop the engine, remove the key and let cool.
10.Check coolant level of recovery tank and add coolant if
necessary.
11.Properly dispose of used coolant.
IMPORTANT■
• Do not start engine without coolant.
• Use clean, fresh water and anti-freeze to fill the radiator.
• When the anti-freeze is mixed with water, the anti-freeze
mixing ratio must be less than 50 %.
• Securely tighten radiator cap. If the cap is loose or
improperly fitted, water may leak out and the engine could
overheat.
W10375100
(1) Secondary Element
(2) Primary Element
(3) Cover
(4) Evacuator Valve
Coolant capacity (with recovery tank)
7.0 L
7.4 U.S.qts
5.8 Imp.qts
(1) Drain Cock
(2) Radiator Cap
(3) Recovery Tank
A : FULL
B : LOW