2NM/2NX/2NY/2NZ/2P0/2P6
1-3-69
Setting the number of lines to be ignored when receiving a fax in the auto reduction mode
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode. If the number of excess lines is
below the setting, those lines are ignored. If over the setting, the entire data on a page is further
reduced so that it can be recorded on the same page.
1. Change the setting using the cursor right/left keys or numeric keys.
Description Setting
range
Initial
setting
Change in
value per step
Number of lines to be ignored when receiving in
the auto reduction mode
0 to 22 0 16 lines
* : Increase the setting if a page received in the reduction mode is over-reduced and too much
trailing edge margin is left. Decrease it if the received image does not include all transmit-
ted data.
2. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
To Next Page
Loading...
