2NM/2NX/2NY/2NZ/2P0/2P6
1-2-2
1-2-2 Unpacking and installation
(1) Installation procedure
Unpacking
Installing the waste toner box
Setup of a toner container
Connecting the cable
Remove the tapes and spacer
Precaution for carrying the machine
Start
Loading paper
Make test copies
Replace the operation panel sheet
(except 240V AC model)
Connecting the power code
Clearing the counter
(maintanance item U927)
Exit maintenance mode
Setting of the fuser pressure release lever
(40 ppm model only)
Power on
Installing software
Output an own-status report
(maintenance item U000)
Completion of the machine installation
Install the paper feeder (option)
*: For service setup only
*: For service setup only
*: For service setup only
To Next Page
Loading...
