2NM/2NX/2NY/2NZ/2P0/2P6
1-3-18
U001 Exit Mainte
Description
Exits the maintenance mode and returns to the normal copy mode.
Purpose
To exit the maintenance mode.
Method
1. Press the start key. The normal copy mode is entered.
U002 Set Factory Def
Description
Restores the machine conditions to the factory default settings.
Purpose
To move the mirror frame of the scanner to the position for transport.
Method
1. Press the start key.
2. Select [Mode1(All)].
3. Press the start key.
It brings near by a left end so that the carriage of Scanner can be fixed.
Display Description
Mode1(All) A factory-default setup is performed.
4. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
* : An error code is displayed in case of an initialization error.
When errors occurred, turn main power switch off then on, and execute initialization using
maintenance item U002.
Error codes
Codes Description
0001 Controller (Entity error)
0002 Controller (Counter error)
0003 Controller (OS error)
0020 Engine
To Next Page
Loading...
Need help?
General
