10.10 Specifying Expert User Mode Functions
10
10-75
Utility Mode Operations Chapter 10
9 If the lines are shifted as shown
at the right, touch to
specify the desired positive
adjustment for “X” (between +1
dot and +6 dots).
10 If the lines are shifted as shown
at the right, touch [Y], and then
touch to specify the
desired negative adjustment for
“Y” (between -1 dot and -6 dots).
11 If the lines are shifted as shown
at the right, touch [Y], and then
touch to specify the
desired positive adjustment for
“Y” (between +1 dot and +6
dots).
12 Press the [Start] key.
The adjusted test pattern is printed on 11 × 17-size paper.
To Next Page
Loading...
