10.10 Specifying Expert User Mode Functions
10
10-87
Utility Mode Operations Chapter 10
6 Compare the width of
the left pages of the
copy sample with the
width of the right pages
to check for the center
of the paper.
7 If the staple position is too far to
the left of the center of the paper,
touch to specify the
desired positive adjustment
(between +1 mm and +7 mm).
8 If the staple position is too far to
the right of the center of the
paper, touch to specify the
desired negative adjustment
(between -1 mm and -7 mm).
9 Touch [Fold Position].
To Next Page
Loading...
