v
3.4 Selecting Output Settings ............................................................3-8
Non Sorting (“Non Sort” Setting) ................................................3-8
Sorting (“Sort” Setting)................................................................3-8
Crisscross Sorting (Crisscross Feeding) ....................................3-9
Stapling (with finisher DF-621 installed) ...................................3-10
Stapling (with finisher DF-626 installed) ...................................3-10
Hole-Punching ..........................................................................3-11
To specify Output settings........................................................3-12
3.5 Specifying a Zoom Setting .........................................................3-13
Automatic Scaling (“Auto Zoom” Setting) .................................3-13
Full Size (“×1.0” Setting)...........................................................3-13
Enlarging (Enlarge Settings).....................................................3-13
Reducing (Reduce Settings).....................................................3-13
Minimizing (“Minimal” Setting) ..................................................3-13
Zooming....................................................................................3-14
Custom Sizing (Manual Zoom Settings) ...................................3-14
To select a Zoom setting ..........................................................3-14
To enter a Manual Zoom ratio ..................................................3-15
To store Manual Zoom ratios....................................................3-15
To recall a stored Manual Zoom ratio.......................................3-16
To specify different vertical and horizontal scaling proportions
(X/Y Zoom settings)..................................................................3-17
3.6 Selecting a Paper/Size Setting...................................................3-18
Automatic Paper Selection (“Auto Paper Select” Setting) ........3-18
Manual Paper Selection ...........................................................3-18
Bypass Tray Selection (Bypass Setting) ..................................3-18
Bypass Reserve Settings for Bypass Tray ...............................3-18
To select the paper drawer.......................................................3-19
To specify the size of the paper in the 1st drawer ....................3-19
To specify the size of the paper in the bypass tray ..................3-21
To set a non-standard (custom) paper size..............................3-22
To store a non-standard (custom) paper size...........................3-23
To select a stored non-standard (custom) paper size ..............3-24
To specify the Bypass Reserve settings for the bypass tray ....3-25
3.7 Selecting Original Settings ........................................................3-27
Single-Sided Original (“1” Setting)............................................3-27
Double-Sided Original (“2” Setting) ..........................................3-27
Books (“Book Copy” Settings) ..................................................3-27
Document Orientation (Original Direction Setting) ...................3-29
Document Binding Margin Position (Margin Setting)................3-31
Thick Documents (“Thick Original” Setting)..............................3-31
To specify Original settings ......................................................3-32
To specify Book Copy settings .................................................3-32
To specify conditions of the original .........................................3-35
To Next Page
Loading...
Need help?
General
