76 User Manual QuickTOC
®
purity
ATEX 2 04E3920
5 Start-up
5.15 Rinse the Injection System und Sample Tubes LAR | PROCESS ANALYSERS AG
5.15 Rinse the Injection System und Sample Tubes
Proceed as follows:
1. Switch to the “Service Action” display (Chapter 7.2.11 from page 86).
2. Rinse the injection system using the “Rinse injection system” function.
3. Rinse the sample tubes using the “Rinse sample tubes” function.
5.16 Costumisation of Application-Specific Settings
Application-specific hardware and parameter changes can be set.
Change the following settings:
• Measurement Parameters (Chapter 7.2.2 from page 68)
• Measurement Channels (Chapter 7.2.7 on page 82)
• Relays (Chapter 7.2.5 from page 79)
• Analog Outputs (Chapter 7.2.19 on page 104)
5.17 Checking Status Parameters
The status parameters on the Status screen must be checked to ensure perfect operation of the analys-
er. Use for the check the start-up log (Tab. 6, page 61), in which all relevant status parameters are re-
corded with associated status information permitted. The status parameters are on the “Status screen”
display (Chapter 7.2.10 from page 85).
5.18 Perform a Calibration
Before the measurements can be started, the analyser must undergo application-specific calibration. A
2-point or multi-point calibration can be used here (Chapter 7.2.3 from page 71).
Notice
Before the first measurement, the injection system and sample tubes must be rinsed.
Notice
If a status parameter differs from the status, contact the LAR Technical Support
(Chapter 15.1 on page 267).
Notice
The calibration standards provided by the user are a prerequisite for calibration
(Chapter 6.2 from page 84).
i
i
i
To Next Page
Loading...