LAR Process Analysers QuickTOC purity - Rinse before Measurement; Purge Time; Rinse after Measurement; Rinse

To Next Page

To Previous Page

114 User Manual QuickTOC

purity

ATEX 2 04E3920

7 How to Work With the Analyser

7.2 Configuration LAR | PROCESS ANALYSERS AG

7.2.16.1 Rinse before Measurement

Here you can set whether the tubing system should be rinsed before a measurement with rinse water

via Y3Y10.

7.2.16.2 Purge Time

If the parameter "Rinse before measurement" is activated, the duration of the rinse must be specified

here.

7.2.16.3 Rinse after Measurement

Here you can set whether the tubing system should be rinsed after a measurement with rinse water via

Y3Y10.

7.2.16.4 Rinse

If the parameter "Purge after measurement" is activated, the duration of the purge must be specified he-

re.

7.2.16.5 Automatic high-salt rinse from the reactor

Choose if and how often rinse water should be injected into the reactor. Maximally, this can be done ev-

ery 30 minutes. Also select how many injections should be made for each rinse.

7.2.17 Database

If you go to the "Database" screen, three screens can be activated for the user Level II:

• Overview of the database

• Table form of the measured data

• Daily course of the measured data

In the first screen "Overview Database" (Fig. 77, page 115) the measured data can be loaded per current

and per day. To see the individual measurement data, click on "stream" and "day" (measurement). The

selection boxes can be activated or deactivated. When the charging process is 100%, the measured

data can be displayed as a table (Fig. 78, page 116) or daily course (Fig. 79, page 117). The "Table form

of the measured data" button can be pressed to display a new table with the selected current and day.