LDI DIGISONDE 4D - CHAPTER 4 _ ADVANCED INTERFACE of DCART; Summary of Advanced Features in Dcart; Cross-Channel Equalizing of the Receiver Channels

LDI Intellectual Property.
Not for secondary distribution or replication, in part or entirety.
DIGISONDE-4D
SYSTEM MANUAL
VERSION 1.2.11
3-68 SECTION 3 - OPERATING INSTRUCTIONS
CHAPTER 4
ADVANCED INTERFACE OF DCART
SUMMARY OF ADVANCED FEATURES IN DCART
3:128. The following categories of DCART operations are considered to be available to advanced users:
• Programming and analysis of Cross-Channel Equalizing (CCEQ) data,
• Programming and analysis of Tracking Filter Calibration data,
• Direct hardware commanding,
• Global redefinition of data production options,
• Commanding of DESC into Diagnostic and Standby state for manual uploads, and
• Manual production of SSTs.
3:129. Use Options – General menu of DCART to switch it into Advanced interface mode, in which DCART
windows shows additional controls and content tabs (see Figure 3-49).
Cross-Channel Equalizing of the Receiver Channels
3:130. The CCEQ operation switches Digisonde-4D into internal loopback configuration, in which antenna
switch is commanded to use loopback signal from Transmitter Card instead of receiving antennas
(Figure 3-49).