Lenze i950 - Page 93

How to commission the technology applicaon:
1. Enter the gearbox rao in the kinemacs dialogue.
a)
In the par
ameter Gearbox factor - numerator, enter the gearbox rao = 12. 40x500A:
033
b)
In the parameter Gearbox factor - denominator enter the gearbox rao = 1. 40x500A:
034
The feed constant has no inuence on the movement in this technology applicaon, but
only denes the unit of the general speed displays. The parameter Feed constant has the
basic seng 360.0000[°]. 40x500A:032
2.
Select the base sengs in the technology applicaon dialogue.
a)
Set the Winding direcon with line velocity > 0 = false. 40x5051:011
The winder will now operate as a rewinder.
b)
Set the Line velocity reference = 1000.0000 [mm/s]. 40x5051:012
The reference speed corresponds to the maximum line speed.
c)
Use Line velocity source = 3 to select the source of the line speed. 40x5020:020
d)
Set the Evaluaon line velocity - numerator = 2387610. 40x5051:007
e)
Se
t the Evaluaon line velocity - denominator = 360000. 40x5051:008
3. Switch to the "Calculate diameter" dialogue.
a)
Enter Min. reel diameter = 76.0000 [mm]. 40x5051:016
b)
Enter Max. reel diameter = 1250.0000 [mm]. 40x5051:017
c)
Enter Start diameter = 76.0000 [mm]. 40x5051:066
4. Switch to the "Manual line jogging" dialogue.
The winder can only be tested in manual operaon. This must be done without
an
y material inside the machine.
a) To load the diameter = 76 [mm], set the value = TRUE in bit 22 of the parameter Con-
tr
ol word. 0x5050:010
b) To move the line in a posive direcon, set the value = TRUE in bit 5 of the parameter
Control word. 0x5050:010
c) To move the line in a negave direcon, set the value = TRUE in bit 6 of the parameter
Control word. 0x5050:010
The direcon of rotaon of the winding sha is set. If the sha rotates in the opposite
direcon, invert the motor mounng posion.
d)
Adapt the direcon of rotaon in the parameter Motor mounng direcon. 40x500A:
035
To do so, refer to the table "Overview of the winding sha’s direcon of rotaon
depending on the bit sengs" at the end of the chapter.
5. Scale the signal of the actual posion of the dancer.
The reference values are congured using the teach funcon.
a) Switch to the "Dancer posion evaluaon" dialogue.
b)
In the parameter Set dancer posion (input value), select = AnalogIn [1].
40x5050:023
c) In the parameter Dancer limit posion source, select = Teached values [TRUE].
40x5052:173
d) In the parameter Stored material length in dancer, enter = 1600.0000 [mm].
40x5052:200
The length is required for the inial diameter
idencaon when liing the dancer.
e) Move the dancer manually to the lower posion.
Conguring the "Winder Dancer" TA
Commissioning
93