Action Yes No
Step 5
Remove the stapler cartridge. Check the stapler cartridge and make sure
obstructions are removed.
Is it free of damage?
Go to step 6. Replace the stapler
cartridge.
Step 6
Remove the left cover. Reseat the cable (J7) on the controller PCBA, then
POR the machine.
Does the error remain?
Go to step 7. The problem is solved.
Step 7
Remove the right cover. Reseat the two cables on the stapler cartridge
end, then POR the machine.
Does the error remain?
Go to step 8. The problem is solved.
Step 8
Remove the stapler cartridge. Using a flashlight, check the sensor
(cartridge present) inside the stapler cartridge assembly. Manually
actuate the sensor flag, and check if it toggles properly.
Is the sensor functioning properly?
Go to step 9. Replace the staple
finisher assembly. Go
to “Staple finisher
assembly removal” on
page 471.
Step 9
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?
Replace the controller
PCBA. Go to “Stapler
controller PCBA
removal” on page
496.
If the error persists,
then replace the staple
finisher assembly. Go
to “Staple finisher
assembly removal” on
page 471.
The problem is solved.
4063
Diagnostic information
213
To Next Page
Loading...
