Lexmark MS81x - Mailbox Upper Interface Cable Removal; Mailbox Divert Motor Removal

Mailbox upper interface cable removal
1 Remove the top cover. See “Mailbox top cover removal” on page 500,
2 Remove the mailbox left cover. See “Mailbox left cover removal” on page 506.
3 Disconnect the upper interface cable (J1B) from the controller PCBA.
4 Crimp both connector pins, using pliers to make them fit the pin holes. Push the connector off its slot.
5 Remove the upper interface cable.
Mailbox divert motor removal
1 Remove the top cover. See “Mailbox top cover removal” on page 500.
2 Remove the mailbox left cover. See “Mailbox left cover removal” on page 506.
3 Disconnect the cable (A) from the divert motor.
4063
Repair information
512