Sensor (mailbox pass through) jam service check
Action Yes No
Step 1
Is the mailbox the only output option installed?
Go to step 4. Go to step 2.
Step 2
Remove all output options and re-install only the mailbox. Enter
Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Go to step 3.
Step 3
Check the auto connector end of the option previously installed below the
mailbox.
Is it free of damage?
Go to step 4. Replace the damaged
upper interface cable
of the output option
previously installed
under the mailbox.
Step 4
Check the lower interface cable. If damaged, replace the lower interface
cable. Go to “Mailbox lower interface cable removal” on page 510.
Re-seat the connector (J1A) on the controller PCBA, then POR the
machine.
Does the error remain?
Go to step 5. The problem is solved.
Step 5
Open the rear door and check the two sensors (pass through) for proper
operation. Enter Diagnostics Menu and navigate to:
Output bin tests > Sensor test
Does the display on the operator panel change every time the sensing
area of the above sensors are interrupted or blocked?
Go to step 7. Go to step 6.
Step 6
Open the rear door and check the sensors (pass through). If damaged,
then replace the mailbox assembly. Go to “Mailbox assembly removal”
on page 500.
Re-seat the sensor connections (J3T and J3B) on the controller PCBA. POR
the machine.
Does the error remain?
Go to step 7. The problem is solved.
4063
Diagnostic information
171
To Next Page
Loading...
