Removal procedures
Keep the following tips in mind as you replace parts:
• Some removal procedures require removing cable ties. You must replace cable ties during reassembly to avoid
pinching wires, obstructing the paper path, or restricting mechanical movement.
• Remove the toner cartridges, imaging unit, and media tray before removing other printer parts. The imaging unit
should be carefully set on a clean, smooth, and flat surface. It should also be protected from light while out of the
device.
• Disconnect all external cables from the printer to prevent possible damage during service.
• Unless otherwise stated, reinstall the parts in reverse order of removal.
• When reinstalling a part held with several screws, start all screws before the final tightening.
Base printer - cover removals
• “Left cover removal” on page 277
• “Rear lower cover removal” on page 280
• “Top cover removal” on page 282
• “Right cover removal” on page 283
• “Rear door removal” on page 285
Left cover removal
1 Open the front door.
2 Pull the media tray from the machine.
4063
Repair information
277
To Next Page
Loading...
