Paper source Size sensing
Duplex
When set to Auto, a size-sensing input option automatically reports the size of media that it contains to the device.
When Off, the printer ignores the size reported by the size sensing hardware. The media size can be set by the control
panel or the data stream.
To change the size sensing setting:
1 From the Configuration menu, navigate to Size sensing.
2 Select Auto or Off, and depending on the printer model, press OK or touch .
3 Press Back or X to return to the Configuration menu.
Panel Menus
The value of this option determines whether the control panel menus are locked or available.
To run the Feed test:
1 From the Configuration menu, navigate to Panel Menus.
2 Choose one of the following:
• On—Enables control panel menus
• Off—Disables control panel menus
PPDS Emulation
The value of this option determines if a printer can recognize and use the PPDS data stream.
Available options:
• Deactivate
• Activate
Download Emuls
This appears only if at least one download emulator (DLE) is installed. The default setting is Disable. All download
emulators (DLEs) are reenabled automatically after two PORs.
Safe Mode
The settings for this menu item are On and Off (default). When enabled, Safe Mode lets the printer operate in a special
limited mode in which it attempts to continue offering as much functionality as possible despite known issues. For more
information about Safe Mode and the Safe Mode print behavior for this model, see “Using Safe Mode” on page 37.
To change the setting:
1 From the Configuration menu, navigate to Safe Mode.
2 Select On or Off to change the setting.
4063
Service menus
245
To Next Page
Loading...
